| Icon |
Filename |
Bytes |
Date/Time |
Description |
![[Up]](../../../../icon/updir_1.gif) |
../ |
![[SUB]](../../../../icon/dir_1.gif) |
sigm_184-192/ |
 |
nzcom.pdf |
586,937 |
2014/3/24 [02:28:30] |
NZ-COM - The Automatic Z-System by Joe Wright - User's Manual by Jay Sage and Bridger Mitchell |
|
nzcom_ger.pdf |
325,526 |
2014/3/24 [02:28:30] |
Same as above translated into german language. A must have on your Z80 system. |
|
z3plus.pdf |
426,919 |
2018/4/6 [14:33:50] |
Z3PLUS The Z-System for CP/M-Plus User's Manual by Jay Sage and Bridger Mitchell. |
|
z3plus_g.pdf |
472,435 |
2018/4/6 [14:39:44] |
Same as above translated into german language. |
|
z3user.pdf |
82,177 |
2014/3/24 [02:28:32] |
The User's Perspective - An Introduction for ZCPR3 - Z80 Command Processor Replacement, Version 3 by Richard Conn. 11 June 1984 ZCPR3 Version 3.0. Thanks to Richard Conn for he give us a lot of more fun with his enhancement of CP/M. |
|
zcpr3_installation_manual.pdf |
231,939 |
2018/4/15 [22:00:36] |
INSTALLATION MANUAL * ZCPR3 -- Z80 Command Processor Replacement, Version 3 by Richard Conn. |
|
zcpr3_installation_workbook.pdf |
46,506 |
2018/4/15 [21:18:02] |
The ZCPR3 INSTALLATION WORKBOOK by Richard Conn - This workbook takes you through the eight steps of ZCPR3 installation. You should have a copy of the Installation Manual (or SAMPLER) handy as you work through it. This workbook will serve to direct your reading of the Installation Manual and provide a place for you to write down information required during the installation process. |
|
ZCPR3_The_Manual.pdf |
8,746,108 |
2018/4/16 [20:25:28] |
|
|
ZCPR3_The_Manual_(ocr).pdf |
9,944,056 |
2018/4/16 [20:25:28] |
|
|
ZSystem_Users_Guide.pdf |
700,466 |
2018/4/15 [23:14:04] |
The Z-System User's Guide is intended to be usable by itself, though it assumes the existence of ZCPR3: The Manual, by Richard Conn. banner |